MSEX0105i – Electronic No Frost Refrigerator Bottom Mount/ Dual Fan - Maestro High 35
3- Disassembling the Freezer Door
• Loose the screws of the intermediary hinge
• Remove the Freezer Door
• Remove the plastic cover and place it on the right-hand side of the rail
4- Preparation of the Plinth / lower Hinge:
• Remove the right lower hinge pin and move the position of the Plinth complement to right side;
• On the left side, place the left lower hinge pin which is available in the KIT
5- Doors preparation:
• On the Refrigerator Door, remove the hinge Bushing, then using a small screwdriver take out the
plastic Cover
• On the left side, do the same operation to remove the finishing plastic Cover
To Next Page
Loading...
