EN
Quick Guide
Before using the appliance carefully read the Health and Safety guide.
Before using the machine, it is imperative that the transport bolts are removed. For more
detailed instructions on how to remove them, see the Installation Guide.
CONTROL PANEL
WASH CYCLE TABLE
PRODUCT DESCRIPTION
1.
3.
2.
5.
4.
7.
6.
8.
1. Top
2. Detergent dispenser drawer
3. Control panel
4. Handle
5. Porthole door
6. Drain pump (behind the plinth)
7. Plinth (removable)
8. Adjustable feet (2)
DETERGENT DISPENSER DRAWER
Compartment *:
Do not insert detergent in this compartment.
Compartment 1: Washing detergent (powder
or liquid)
If liquid detergent is used, the removable plastic
partition A (supplied) should be used for proper
dosage.
If powder detergent is used, place the partition
into slot B.
Compartment 2: Additives (fabric softeners, etc.)
The fabric softener must not exceed the “MAX” level.
! Use powder detergent for white cotton garments, for pre-washing, and
for washing at temperatures over 60°C.
! Follow the instructions given on the detergent packaging.
1. ON/OFF button
2. KEY LOCK button and indicator light
3. OPTION button and indicator light
4. CLEANING ACTION button
5. CLEANING ACTION indicator lights
6. START/PAUSE button and indicator light
7. DELAY TIMER button and indicator light
8. DRY button
9. SPIN button
10. TEMPERATURE button
11. WASH CYCLE SELECTOR knob
For all testing institutes:
The programme used for the evaluation of (WDFB8614AJW) under the mandatory Water
Eciency Labelling Scheme (WELS) and the recommended Washing Programme for soiled
clothes is as follows : Eco Cotton 60°C.
2) Long cotton cycle: set wash cycle 4 with a temperature of 40°C.
3) Long synthetics cycle: set wash cycle 6 with a temperature of 40°C.
* By selecting the cycle and excluding the spin cycle, the washer-dryer will drain only.
The cycle duration indicated on the display or instruction manual is an estimate based on
standard conditions. The actual duration may vary in relation to several factors, such as
the temperature and pressure of the incoming water, ambient temperature, amount of
detergent, load quantity and type, load balancing and any additional options selected.
1) Test programme in compliance with standard EN 50229 (Wash):
This cycle is designed for normally soiled cotton loads and is the most ecient in terms of
both electricity and water consumption; it should be used for garments washable at 60°C or
at 40°C. The actual washing temperature may dier from the indicated value.
Test programme in compliance with standard EN 50229 (Drying): select the “Drying
Cotton” programme and set the drying level to “A4”, for both loads. The rst drying cycle must
be carried out with the nominal load.
Maximum load 8 kg
Power input in o mode 0.5 W / in left-on mode 8 W
Detergents and
Additives
Recommended
detergent
Wash cycle
Temperature
Maximum
spin
(r.p.m.)
Max.
load
(kg)
Duration
(Minutes)
Drying
Wash
Fabric
softener
Powder Liquid
Default Range
1 2
1 Anti-Stain 40 °C
- 40 °C 1400 5
The duration of the wash cycles can be checked on the display.
–
2 Anti-Stain Quick 40 °C
- 40 °C 1200 4,5
–
3 Whites 60 °C
- 90 °C 1400 5
4 Cotton (2) 40 °C
- 60 °C 1400 8
–
5
Eco Cotton (1) 60 °C - 60 °C 1400 8
6 Synthetics (3) 40 °C
- 60 °C 1000 4,5
–
7 Anti Allergy 60 °C
- 60 °C 1400 5
8 Wool 40 °C
- 40 °C 800 2
–
9 Delicates 30 °C
- 30 °C 0 1
–
10 Fast Wash 30’ 30 °C
- 30 °C 800 3,5 –
–
11 Wash & Dry 45’ 30 °C
- 30 °C 1400 1
–
12 Drying Cotton – – – 6
– – – –
13 Drying Synthetics – – – 4
– – – –
14 Drying Wool – – – 2
– – – –
Rinse – – 1400 8
–
– –
Spin+Pump Out * – – 1400 8
– – – –
Required dosage Optional dosage
1
11
2
DISPLAY
5
6
7
8
9
10
43
THANK YOU FOR BUYING A WHIRLPOOL PRODUCT.
In order to receive a more complete assistance,
please register your appliance on
www.whirlpool.com.sg
To Next Page
Loading...
