What does “PF” (power failure) mean on my Whirlpool WED7300DW Dryer?
The “PF” (power failure) code on your Whirlpool dryer indicates that the drying cycle was interrupted by a power failure. To resolve this, touch and hold START to restart the dryer cycle, or touch power to clear the display.
Why does my Whirlpool WED7300DW Dryer make a thumping noise?
If your Whirlpool Dryer is making a thumping noise, especially if it hasn't been used in a while, this is normal. The sound should diminish after a few minutes of use.
What does “L2” Diagnostic Code mean on Whirlpool WED7300DW Dryer?
The “L2” diagnostic code on your Whirlpool Dryer indicates a low or no line voltage condition, which may prevent the dryer’s heater from turning on. The dryer will continue to run when this code is present. Touch any pad to clear the code from the display and return to the estimated time remaining. Check to see if a household fuse has blown or circuit breaker has tripped. Confirm that the power cord is properly installed. Select a Timed Dry heated cycle, and restart the dryer. If the message persists, consult a qualified electrician.
General| Color | white |
|---|---|
| Dryer Capactity | 7.0 cubic feet |
| Number of Cycles | 10 |
| Cycle Selections | mixed, casuals, towels, delicates, bulky, normal, sanitize, gentle, steam refresh, timed dry |
| Options | static reduce, end beep, damp bep wrinkle shield option, eco boost option, steam refresh |
| Stackable | no |
| Venting | no |
| Temperature Settings | 5 |
| Temperature Selections | no heat, low, medium, high, hot |
| Temperature Control | yes |
| Control Type | electronic |
| Delay Start | no |
| Child Lock | no |
| Cycle Signal | yes |
| Interior Light | yes |
| Drying Rack | no |
| Moisture Sensor Option | yes |
| Steam | yes |
| Voltage | 240 volts |
Weight and Dimensions| Depth | 28.25 inches |
|---|---|
| Height | 40.25 inches |
| Width | 29 inches |
| Net Weight | 121 pounds |
To Next Page