9
20. Plug into a grounded 3 prong outlet
COMPLETE INSTALLATION
CHECKLIST
q
Check electrical requirements. Be sure you have correct
electrical supply and recommended grounding method.
q
Check that all parts are now installed. If there is an extra part,
go back through steps to see what was skipped.
q
Check that you have all of your tools.
q
Check that transport materials were completely
removed from back of washer.
q
Check that both hot and cold hoses are attached and water
faucets are on.
q
Check for leaks around faucets, valves, and inlet hoses.
q
Remove protective lm from console and any tape
remaining on washer.
q
Check that washer is plugged into a grounded
3 prong outlet.
q
Dispose of/recycle all packaging materials.
q
Read “Using Your Washer” in your Washer “Use and Care
Guide”.
q
To test and clean your washer, press power and choose the
QUICK WASH cycle and run it without clothes. Use only HE
detergent. Use 1/2 the manufacturer’s recommended amount
for a medium-size load.
If washer is not level, use a 9/16" or 14 mm open-end or
adjustable wrench to turn jam nuts clockwise on feet until they
are about 1/2" (13 mm) from the washer cabinet. Then turn the
leveling foot clockwise to lower the washer or counterclockwise
to raise the washer. Recheck levelness of washer and that all
four feet are rmly in contact with the oor. Repeat as needed.
HELPFUL TIP: You may want to prop up front of washer
about 4" (102 mm) with a wood block or similar object that
will support weight of washer.
When washer is level and all four feet are rmly in contact with
the oor, use a 9/16" or 14 mm open-end or adjustable wrench
to turn jam nuts counterclockwise on leveling feet tightly
against washer cabinet.
HELPFUL TIP: You may want to prop washer with
wooden block.
18. Adjust leveling feet
Jam nut
19. Tighten leveling feet
Jam nut
To Next Page
Loading...
Need help?
General
Weight and Dimensions
