22
X/K Filter Modes
Recently, many new products operate on X or K band causing
nuisance alerts to radar detectors. Some of these are radar
based Traffic Monitoring Systems mounted to poles alongside
the highway and others are K Band Lane Change Assistants and
Blind Spot Detectors found on some automobiles. The X/K Filter
Mode offers multiple levels of rejection to reduce false alerts
caused by these systems.
Ka Filter Modes
There are times when a radar detector in another vehicle, can
emit a frequency which can cause your detector to falsely alert.
The Ka Filter Modes allow you to select the level needed for your
area to minimize the occurrences of these false alerts.
Filter Mode is the factory default setting and should provide
adequate filtering for most conditions. If you experience
excessive alerts due to radar detectors in other vehicles, increase
the Filter level. See Option Selection Mode to change the filter
settings.
Field Disturbance Sensor Rejection (FDSR)Traffic Flow Sensor
Rejection (TFSR)
Recently many new products that operate on police radar
frequencies have been causing nuisance alerts to radar detectors.
These radar based sensors are installed alongside the Highway
and more recently on vehicles used as lane change assist / blind
spot detectors / collision avoidance systems that operate within
the same band as police radar and provide a brief less intrusive
alert to keep you informed and aware. A signal strength indicator
will help determine your proximity to the source without the
OPERATION
To Next Page
Loading...
Need help?
General
