29
Stay Alert Feature
The Stay Alert Feature is designed to test a driver’s alertness.
To engage (when the unit is not alarming):
• Press and hold the City button for approximately 2
seconds. Release the button during or immediately after
the alert is given.
Display shows:
Within 30-60 seconds, two beeps are sounded; to show
alertness, the driver must press either the City, Menu, or
Quiet buttons within 3-5 seconds. If a button is pressed within
3-5 seconds, the cycle is repeated. Before unit alerts, press
PWR to exit this feature. If a button is not pressed within 3-5
seconds, an alarm sounds.
Display shows:
• Press the DARK button to exit during the Get Rest
message.
WARNING!!! Stay Alert is NOT intended as a substitute for
adequate rest. You should NOT operate a vehicle if you are
drowsy. During extended periods of vehicle operation, you
should take frequent breaks. Improper reliance on the Stay Alert
feature may result in vehicle damage, personal injury or death.
NEVER OPERATE A
VEHICLE IF YOU
ARE DROWSY!
OPERATION
To Next Page
Loading...
Need help?
General
