33
PROBLEM: Unit alarms when vehicle hits bumps.
• Check for loose lighter socket; tighten and clean.
• Check connections at both ends of the power cord.
Substitute another cord to determine if the cord is
defective. Return defective cord to the factory.
PROBLEM: Unit Ka falses too much.
• If your country only uses 34.0, 34.3 GHz use Ka Narrow
Mode.
• If alarms are POP Ka, switch POP Mode to off.
• If the above option doesn’t help, use a higher Ka Filter
setting.
• If alarms are X or K band and due to radar based traffic
flow sensors or radar based vehicle blind spot detectors,
use a higher X/K Filter setting.
If difficulties occur which cannot be solved by information in this
Troubleshooting Guide, please call Whistler Customer Service at
1-479-273-6012 or visit our FAQ page at
www.whistlergroup.com, before returning your unit for service.
TROUBLESHOOTING
To Next Page
Loading...
