9
Windshield Mounting
• Install the two suction cups and rubber bumper onto the
bracket by fitting them into their holes.
• Press the suction cups onto the windshield at the location
you have chosen.
IMPORTANT: Some newer cars have a plastic safety coating
on the inside of the windshield. The windshield bracket may
leave permanent marks on this type of surface. To find out if
your vehicle has this type of windshield, check the vehicle’s
owner’s manual or ask your dealer. We recommend that you
do not leave the suction cup bracket on the window in direct
sunlight. If the detector is removed, this may cause blistering
of the dash in some vehicles.
• Slide the detector onto the bracket until it locks into place.
• If necessary, the unit may be leveled by bending the
windshield bracket. Press the bracket release button and
remove the detector before bending.
Rubber
Bumper
INSTALLATION
To Next Page
Loading...
