20
Locking Out Channels
You can increase the scanning or search speed by
locking out channels or frequencies that have a
continuous transmission, such as control channels,
weather channels, or birdie frequencies.
Press L/O when the scanner stops on a channel or
frequency while scanning or searching. The scanner
locks out the channel/frequency then continues
scanning/searching.
To manually lock-out a channel, select the channel
then press L/O.
L/0
appears in the display.
• Your scanner automatically locks out empty
channels.
• You can still manually select locked-out channels.
• You can lock-out a maximum of 50 frequencies
during a search. If you try to lock-out more, L- O
Fr-FULL appears.
Managing Lock-outs
1. Set the scanner to manual by pressing SCAN/
MAN until MAN appears
2. Hold down L/O
/
L/O RV W for about two seconds.
The scanner pulls up a locked out channels.
3. Press and hold L/O
/
L/O RV W to show the next
locked out channel. If an error beep sounds, there
are no locked out channels.
4. To remove the lock-out, press L/O
/
L/O RV W until
L/0
disappears.
Managing Service Bank Lock-outs
1. Hold down L/O
/
L/O RV W for about two seconds
during a Service Bank search.
2. Press or repeatedly to scroll through the list
of locked-out frequencies. L- r and
L/0
appear in
the display.
3. Press L/O
/
L/O RV W to remove the lock-out. The
list scrolls to the next locked-out frequency.
• When you reach the highest locked-out
frequency, the scanner beeps twice and rolls to
the lowest locked-out frequency.
• If the Service Bank has no locked-out frequencies,
EMPty appears.
LOCKING OUT
To Next Page
Loading...
Need help?
General
