Whistler WS1065 User Manual

7
Setup
Antenna
You scanner's antenna connects easily, or you can
use a variety of antennas, such as an external mobile
antenna or outdoor base station antenna.
To connect an external antenna, follow the
installation instructions supplied with the antenna.
Always use 50-ohm coaxial cable, such as RG-58 or
RG-8 low-loss dielectric coaxial cable. You may also
need a BNC adapter.
To connect the included antenna:
Your scanner’s frequency sensitivity depends on its
location and the antenna length. For best reception,
adjust the antenna’s length as follows:
FREQUNCY ANTENNA LENGTH
25-54 MHz Extend fully
108-174 MHz Extend 4 segments
216-225 MHz Extend 3 segments
225-406 MHz Extend 2 segments
406-1300 MHz Collapse fully
1. Align the slots.
2. Rotate connector.
INSTALLATION OF ANTENNA

Whistler WS1065 Specifications

General

Channels	1800
Trunking Systems Supported	Motorola, EDACS, LTR
Memory Banks	20
PC Programmable	Yes
Type	Digital scanner
Display	LCD with backlight
Power	AC adapter
Modulation Modes	AM, FM, P25
PC Connectivity	Yes
Battery Type	AA
Audio Output	3.5 mm headphone jack
Frequency Coverage	25-54 MHz, 108-174 MHz, 216-512 MHz, 764-960 MHz