9
Desktop Operation
The mounting bracket works as a desktop stand when
attached underneath the radio. Use the provided rubber
feet to prevent sliding or scratching. Do not use the
rubber feet if mounting permanently to a fixed surface.
Extra pads are provided for additional stability.
1. Attach the adhesive rubber feet to the mounting
bracket.
2. Attach the two adhesive rubber washers over the
mounting holes, between the mounting bracket
sides and the scanner’s side holes.
3. Position the bracket with the two recessed fee
toward the front of the scanner.
4. Use the two provided knobs to secure the scanner
within the mounting bracket.
Mount Installation
Attach the bracket over the radio to suspend the
scanner from above. Attach the bracket underneath
the scanner to mount it on top of a flat surface. Your
WS1065 also fits into the included DIN-E compatible
sleeve for existing dashboard openings.
NOTE: In some cases, installation requires specialized
tools and skills. If in doubt, seek assistance from a local
car audio electronics installation shop, or a local two-
way radio dealer.
Select a location that does not interfere with driving or
with the deployment of your vehicle’s air bags. Do not
mount this or any other equipment where deployment
of the air bags might cause it to be propelled towards
passengers. If necessary, seek advice from your
automotive dealer or service shop.
DESKTOP OPERATION
To Next Page
Loading...
Need help?
General
