4
MODEL 4100 STEREO EQUALIZER USER'S MANUAL
INTRODUCTION
Congratulations'. You have purchased the finest one octave stereo equalizer that money
can buy. White Instruments stands behind this product, as we do all products we
manufacture, in guaranteeing that the highest standards of quality and craftsmanship have
gone into the construction of your Model 4100 Stereo Equalizer. Properly installed, this
unit will provide you with years of trouble-free operation. Please read the instructions
carefully – by following them you will realize a standard in music reproduction that
previously could only be hoped for.
UNPACKING
Your Model 4100 Stereo Equalizer has been carefully packaged to minimize the
possibility of damage during shipment. When you receive your unit, unpack and carefully
inspect it. If there is any obvious damage, report it immediately to the dealer from whom
you purchased it or to the carrier who delivered it. Save all packing materials for
inspection by the dealer or carrier. As all products from White Instruments are shipped
F.O.B.
Factory, we are not responsible for damage incurred during shipment; however,
we will assist you in obtaining rapid repairs or replacements.
Inside the plastic foam shipper you will find the following:
l. One Model 4100 Stereo Equalizer
2. One Security Cover
3. Two hi-fi stereo patch cables
4. One 3-wire line cord adaptor
5. One User's Manual
6. One set of hardware (if you ordered the 4100
RM
(rack mounting) unit)
We recommend you retain all packing materials in case the unit must be returned to your
local service center or the factory for repair.
CONNECTION TO THE SYSTEM
NOTE:
Even if you do not like to read instructions, please read the section,
CONNECTION TO THE SYSTEM, to protect your investment in your music system. It is
possible to damage some high frequency loudspeakers or tweeters by excessively
boosting the upper portions of the spectrum.
The Model 4100 Stereo Equalizer is designed to be connected between your preamplifier
and your power amplifier. The instructions for doing this follow.
The input impedance of the Model 4100 is high – greater than 40,000 ohms. This means
that it will not appreciably "load" the output. circuit of modern high fidelity preamplifiers
and may be connected without consideration of impedance matching methods. The output
To Next Page
Loading...