White 1634 - Cutting Width Adjustment; Proper Cutting Width; Adjusting to Wider Cutting Width; Adjusting to Narrower Cutting Width

CHANGING THE THREAD
(TYING ON)
It is simple
to change
the thread in
the
following
manner.
The
Built in pocket handle is a convenient way
to carry your machine.
Cut the thread above the spool pin, and knot
ends
of old and
new threads together.
Set the tension dials to
“0”
and raise the
presser foot.
Pull the other end of thread until knots come
under the presser foot. For needle threads, pull
the other
ends
of threads until knots
come to
needle
eyes and cut the threads at the both
sides of the knots. Then re-thread the needles.
I
BUILT-IN POCKET HANDLE
Pocket
handle
- 16-