White 8000 - Making Buttonholes; Buttonhole: Determine the Length

With the
right sides
of
the
material together,
hand tack
on the seam
line the exact
length of
the opening.
Open the tacked seam
and fold
under the back seam
allowance
0.3cm
(1/8”l
from fre
tacked
seam.
Place the folded
edge
over
the
right side of the zipper and
hand-tack on it
as
shown.
Set
the
foot holder on the
right pin
of
the
zipper foot so
that
the needle comes to
the
right groove. Stitch from
the
bottom
to the top. Remove the
hand tacking.
Turn the mater a)
to
the right
side. Ease
the material and the
zipper. Hand tack 1 3cm(1/2”)
from
the
wrapped
edge as
a
stitching guide.
Shift the zip
per foot
to the right of
the
needle
Double stitch
across
the lower
end, ther up along
the
zipper. Remove
trie dod
tacking.
19. MAKING BUTTON
HOLES
Determine the Length
Measure the diameter
and the
thickness of the
button
and
add 0.3cm(1 8”)
for
bar
tacks.
Mark the buttonhole
size on
the material.
----i
O.3cm(1/8”)
diameter
length
of
a
buttonhole
____________
thickness
guide lines
30