9.4: Location Of Bosch Battery Charge Port
IMPORTANT: At all times follow closely all recommendations from Bosch contained in the relevant Bosch Customer
User Manual documentation material bundled with your bike (or consult the on-line Bosch resources) to fully understand
how to re-charge, handle and store your Bosch Battery. Failure to comply with all Bosch recommendations could lead to failure
of the battery function, and risk of fire leading to serious injury and death.
The position of the remote charge port for the Bosch Battery has been integrated into the top of the Motor Mount as can be
seen in Figure 21a and 21b. To access the charge port, peel back the sealed cover of the Charge Port marked “Whyte Energy”
to reveal the charge port. Follow the instructions contained in the Bosch Battery Instruction Manual to Charge the Battery.
When Charging has finished, re-fit the Remote Charge Port Cover and press firmly to seal the Cover over the Charge port to
prevent ingress of mud and water and other contaminants.
10.0: TORQUE SETTINGS
IMPORTANT: For all other torque settings, refer to the specific manufacturers information bundled with this manual, or
alternatively, refer to the specific manufacturers website for further information.
Figure 21a Figure 21b
Rear Suspension Nm lbs.ft
M5 Socket-head Cap Screw (T-25 Torx)
5.0 (Min) - 6.0 (Max) 3.7 (Min) - 4.4 (Max)
M15 x 20 long Alloy Flanged Screw
15.0 (Min) - 17.0 (Max) 10.5 (Min) - 12.5 (Max
M15 x 28 long Alloy Flanged Screw
22.0 (Min) - 26.0 (Max) 16.2 (Min) - 19.2 (Max)
M15 x 87 long Pivot Pin
9.0 (Min) - 11.0 (Max) 6.1 (Min) - 7.5 (Max)
M6 x 20 long Socket Head Capscrew
9.0 (Min) - 11.0 (Max) 6.1 (Min) - 7.5 (Max)
Rear Dropout Assembly
8mm Sram UDH Fixing Bolt
21.0 (Min) - 25.0 (Max) 15.4 (Min) - 18.4 (Max)
Seat Post Clamp
M5 Cap Screw
6.0 (Min) - 8.0 (Max) 4.4 (Min) - 5.9 (Max)
DownTube Lower Cover
5mm Socket Head M10 screw
9.0 (Min) - 10.0 (Max) 6.6 (Min) - 7.4 (Max)
To Next Page
Loading...