EasyManua.ls Logo

Whyte E-180 S MX - 1.0 Introduction; 2.0 Geometry; 3.0 Preparations for Riding; 3.1 Making Adjustments

Default Icon
25 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1.0: INTRODUCTION
Thanks for choosing to purchase this Whyte product. We hope you will enjoy all the benefits its advanced design and engineeri ng
will bring to your riding experience.
This manual will guide you through the set-up, safety and maintenance procedures that are specific to your Whyte bike. For
other more general information, we strongly advise that you also read thoroughly the General Instruction Manual that is also
supplied with your new bike.
Also, please note that the specification of all the components that are fitted to your bike as standard may be obtained from the
Whyte Bikes website www.whytebikes.com
Please remember, if you are in any doubt about your ability to safely service or repair your Whyte bike, DO NOT RIDE IT and
instead arrange for a professional bicycle mechanic at your local Whyte dealer to do the job correctly.
Bundled with this manual, may be some of the respective manufacturers instructions and manuals for the branded parts that are
fitted to your Whyte bike. Please take time to study all the relevant instruction manuals to ensure you have a continually safe
and well set-up bike before every ride, and to help you build up a relationship of knowledge between you and your Whyte Dealer.
Happy and safe riding,
Whyte design team.
2.0: GEOMETRY
The geometry of the full suspension range of Whyte Bikes is available from the Whyte Bikes website www.whytebikes.com
Note: The designation MXis used on bike models that use a 29” front wheel and a 27.5” rear wheel
3.0: PREPARATIONS FOR RIDING
3.1: MAKING ADJUSTMENTS
Please refer to the specific component manufacturers manual or published technical information about adjusting the compo-
nents on your Whyte bike. Instructions may be downloaded from the relevant manufacturers internet site, as shown in the
table below.
CAUTION! If you are uncertain in any way, about making adjustments to any components on you Whyte bike, then DO
NOT RIDE YOUR BIKE.
Contact your Whyte dealer who will be able to advise you on how to go about setting up you Whyte bike for riding, and or mak-
ing adjustments to the components fitted to your Whyte bike.
Bosch www.bosch-ebike.com
Crank Brothers www.crankbrothers.com
DT Swiss www.dtswiss.com
Easton www.eastoncycling.com
Formula www.formulahubs.com
Fox www.ridefox.com/subhome.php?m=bike
Hope www.hopetech.com
Joytech www.joy-tech.com.tw
Maxxis www.maxxis.com
Race Face www.raceface.com
Shimano www.shimano.com
SRAM www.sram.com
TRP www.trpcycling.com
WTB www.wtb.com

Related product manuals