WIA WELDARC 200AC/DC - Receiving and Operation; Receiving Equipment

Weldarc 200 AC/DC | Operator Manual | Model No MC114-2
98
2 RECEIVING
Check the equipment received against the
shipping invoice to make sure the shipment
is complete and undamaged. If any damage
has occurred in transit, please immediately
notify your supplier.
The Weldarc inverter package contains:
– Weldarc Inverter Power Source
– Twist-lock Electrode Holder
– Work Clamp 3m
– Gas Hose
– (This) Operating Manual MC114-40.
– TIG Torch Complete WP17V121625
with valve, 5m cable with twist-lock
connection and fitted with 2.4mm
collet and ceriated tungsten
– TIG Consumable KIT
– Argon flow gauge regulator REG003
3 OPERATION
Whenever the welding output of the
Weldarc inverter is open circuit (ie not
arcing), the voltage across the welding
leads is reduced to a safe level. This
provides an increased level of safety to the
welding operator during operations such as
changing the electrode. The “VRD SAFE”
indicator on the front panel is on to confirm
the output is in the safe condition.
The term VRD refers to a “Voltage Reducing
Device”which complies with AS1674.2 for
Category “C” conditions.
If the supply cable is damaged it
must be replaced by the manufacturer,
their service agent or a similarly
qualified person.
IMPORTANT NOTICE: Warranty
may be voided if equipment is
powered from an unsuitable engine
driven generator.
Generators used to power this
equipment must have a minimum
capacity of 10 kW continuous and
incorporate output voltage regulation.
Due to variation between generators
by different manufacturers, it is
impossible for WIA to validate
operation from all generators.
Therefore, we recommend that
operation of equipment on the
generator is received from the
manufacturer before purchasing
the generator.