ASSEMBLE YOUR
WICKED EDGE®
Step 1: Position the Degree Bar in the
bottom channel of the Base with the
numbers facing up and the detents facing
the same direction as the logo on the Base
as shown in Figure 12.
Step 2: Note that only one hole in the Base
is threaded. Insert the 1/2 inch Socket-Head
Cap Screw into the hole in the Degree Bar
that is lined up with the threaded hole in the
Base. Then fasten the Degree Bar to the
Base. Do not over tighten.
Step 3: Place the Fixed Vise Jaw in the top
channel of the Base, above the non-thread-
ed hole in the channel.
Step 4: Insert the 1 inch Socket-Head Cap
Screw through the Degree Bar and Base and
screw it into the Fixed Vise Jaw using the
long end of the Vise Key.
Do not over tighten.
20 • assembly guide • wickededgeusa.com
Fig. 12
To Next Page
Loading...
