35
Adjusting the anchor: The an-
chor should form an appropri-
ately sized loop to ensure the
comfortable retention of the é-
tip in your ear canal. It is formed
by pulling the tip of the anchor
through the small hole on the
side of the élan ear-set.
When the loop is the correct
size, any excess should be cut
off, leaving only the loop. Take
great care to cut off all the ex-
cess so that the end of anchor
loop is flush with the small hole
and there are no sharp edges.
Use the tip of your finger to
check for sharp edges. If part of
the anchor sticks out through
the hole, creating an uneven surface, this may cause
ear irritation.
The correct size is obtained when the anchor loop com-
fortably supports the position of the é-tip in the ear canal,
so that the élan ear-set sits securely in and on the ear.
To Next Page
Loading...
