widos 4400 - Heating Element; Planer

Kunststoffschweißtechnik
Description of Product Chapter 1
23.06.15 Working Instructions WIDOS 4400 Page 8 of 44
Environmental conditions at the
welding area:
- Keep the workshop clean (no dust at the welding
area)
- If secured by an appropriate measurement that
allowed conditions for welding are indicated, it is
possible to work in any outside temperature
condition as far as the welder is not constrained in its
manual skill.
- Avoid humidity, if necessary use a welding tent
- Avoid strong sun rays influence
- Protect from wind, shut the pipe ends.
1.5.1.2.
Heating element
Power: 800 Watt
Voltage: 230 V (r 10 %)
Current: 3,5 A (r 10 %)
Frequency: 50 Hz
Outside-: 200 mm
Surface: Nonstick-coated
Attached elements: - Electronic temperature control
- On / off switch red illuminated
- Control lamp green
- Connecting cable and plug
Weight: appr. 3,5 kg
1.5.1.3.
Planer
Motor: Monophase-alternating current-motor
Power: 950 Watt
Voltage: 230 V (r 10 %)
Current: 4,1 A
Frequency: 50 Hz (r 10 %)
RPM n of planer: 100 rpm
Attached elements: - Switch on/off with fixing device
- Connecting cable and plug
Weight: appr. 7,5 kg