26 WIKA operating instructions, model CPG1200
EN
14603921.02 06/2023 EN/DE
5. Put the battery cover on and screw it tight with the three screws.
▶
Maximum tightening torque of the screws is < 0.4 Nm.
Fig. 1 - Position of the battery compartment
6.2.2 Mains operation via USB power supply unit
DANGER!
Danger to life caused by electric current
Upon contact with live parts, there is a direct danger to life.
▶
Operation using a defective power supply unit (e.g. short-circuit from
the mains voltage to the output voltage) can result in life-threatening
voltages at the instrument!
▶
If there is any visible damage to the case or the wiring, do not use the
power supply unit!
▶
Never install nor store the power supply unit in the following locations, as
this can lead to a failure in operation:
■
Places where there is strong humidity or condensation
■
Outdoors
▶
Disconnect the power supply unit from the mains supply when it won't be
used for a longer period of time.
6. Commissioning, operation
To Next Page
Loading...
