To Next PageTo Next Page
Need help?Do you have a question about the WIKA S-11 and is the answer not in the manual?
General| Type | Pressure Transmitter |
|---|---|
| Medium Temperature | -20 ... +100 °C |
| Housing Material | Stainless steel |
| Measuring Range | 0 ... 0.1 to 0 ... 1000 bar |
| Output Signal | 4...20 mA, 0...10 V, 0...5 V, 1...5 V |
| Power Supply | 10 ... 30 V DC |
| Accuracy | ±0.5 % FS |
| Temperature Range | -20 ... +80 °C |
| Process Connection | G 1/2, G 1/4, 1/4" NPT, 1/2" NPT |
| Electrical Connection | M12 x 1 |
| Ingress Protection | IP65 |
Specifies that the pressure transmitter is for converting pressure into electrical signals and must be used accordingly.
Details the required qualifications and knowledge for personnel handling the instrument safely.
Highlights hazards associated with specific media like oxygen, acetylene, flammable or toxic gases.
Details available measuring ranges for relative, absolute, and vacuum pressure in bar.
Provides step-by-step instructions for mechanically mounting the pressure transmitter, including handling the diaphragm and spanner flats.
Details earthing requirements, cable selection, plug fitting, and ensuring a tight seal for ingress protection.
Outlines steps to prepare for adjustment, including disconnecting the electrical connection and connecting to power supply.
Explains how to use potentiometer 'Z' to adjust the minimum output signal at the start of the measuring range.
Explains how to use potentiometer 'S' to adjust the maximum output signal at the end of the measuring range.
Details how to finish the adjustment, re-connect the connector, and check system functionality.
Provides warnings and instructions for safely dismounting the instrument, including cooling and depressurizing the system.
