Need help?Do you have a question about the WIKA UPT-20 and is the answer not in the manual?
General| Brand | WIKA |
|---|---|
| Model | UPT-20 |
| Category | Transmitter |
| Language | English |
Details the physical components and layout of the process transmitter.
Explains the fundamental function of the process transmitter and its output signal.
Lists the items included with the pre-assembled process transmitter and ordered accessories.
Defines danger, warning, caution, and information symbols used in the manual.
Specifies the correct applications and ATEX/IECEx approval ratings for hazardous areas.
Outlines specific requirements for safe operation, especially in Zone 0.
Defines the necessary skills and knowledge for personnel operating the instrument.
Addresses risks in hazardous areas and guidelines for handling hazardous media safely.
Explains the information provided on the product label and relevant safety marks.
Provides instructions for safe transport and optimal packaging of the instrument.
Specifies permissible environmental conditions and factors to avoid during storage.
Details the necessary conditions and considerations for the mounting point of the transmitter.
Guides on mounting the transmitter, including diaphragm protection and sealing methods.
Outlines essential safety instructions for electrical connections, including voltage and cable requirements.
Specifies requirements for intrinsically safe circuits and voltage supply separation.
Provides instructions on opening the transmitter case and details grounding and shielding practices.
Step-by-step guide for connecting the cables, tightening the gland, and performing mounting correction.
Illustrates the pin assignments for different electrical connectors and terminals.
Introduces the DI-PT-U display and operating unit and its features.
Explains how to navigate and exit the menu structure using the unit's buttons.
Provides instructions on how to install and remove the display and operating unit.
Guides on configuring the primary display to show desired measurement values.
Details how to configure the secondary display for additional information or drag pointer values.
Describes how to set a new zero point to compensate for mounting position effects.
Explains how to connect and configure the transmitter using a HART® modem and PC.
Guides on setting up the primary measurement application (pressure, level, volume).
Instructions for setting pressure, length, volume, density, and temperature units.
Details procedures for performing wet and dry adjustments to scale the measuring range.
Explains how to define the measurement parameter transmitted via the current output.
Provides methods for performing wet and dry adjustments for mounting correction.
Describes how to adjust damping to reduce output signal fluctuations.
Guides on activating/deactivating write protection and changing the device PIN.
Instructions for simulating pressure and current outputs for testing purposes.
Explains how to view and reset minimum/maximum values for pressure, PV, and temperature.
Details how to display and reset the instrument's accumulated operating time.
Options for selecting the user interface language from available options.
Guides on setting short and long TAG identifiers for the measuring point.
Configures alarm signal behavior and defines acceptable output signal limits.
Instructions for adjusting the brightness and contrast of the liquid crystal display.
Procedure for resetting instrument and drag pointer values to factory defaults.
Configuration of HART® communication, including short address and constant current.
Shows how to view the configured measuring range and general display settings.
Information on the date of manufacture, firmware version, and serial number.
How to retrieve the device's serial number, including HART® serial number.
Guidelines for regular maintenance, cleaning the cooling element, and general care.
Recommendations for periodic recalibration to maintain accuracy.
Instructions for safely dismounting, returning, and shipping the instrument.
Information on environmentally responsible disposal of instrument components and packaging.
Details the instrument's measuring ranges, accuracy, and behavior with turndown.
Covers operating conditions, permissible temperature ranges, and ignition protection types.
Information on materials used, sealing types, and case head specifications.
Details specifications for display unit, output signal, damping, and voltage supply.
Information on ingress protection, reference conditions, and CE conformity directives.
Provides dimensional drawings and details of process connection options for UPT-20.
Details the various process connection options available for the UPT-21 model.
To Next Page
