WIKA UPT-20 User Manual

53
WIKA operating instructions process transmitter, model UPT-2x
14111166.02 04/2015 EN/DE
EN
13. Faults / 14. Dismounting, return and disposal
CAUTION!
If faults cannot be eliminated by means of the measures listed above, shut
down the process transmitter immediately, and ensure that pressure and/or
signal are no longer present, and secure the instrument from being put back
into operation inadvertently.
In this case, contact the manufacturer.
If a return is needed, please follow the instructions given in chapter 14.2
“Return”.
14. Dismounting, return and disposal
WARNING!
Residual media in the dismounted process transmitter can result in a risk to
personnel, the environment and equipment.
Take sucient precautionary measures.
14.1 Dismounting
Switch the pressure measuring instrument to a depressurised and unpowered state.
Observe the information given in the type examination certicate and the country-specic
regulations for installation and use in hazardous areas (e.g. IEC 60079-14, NEC, CEC)
. If
this is not observed, serious injuries and damage could occur.
14.2 Return
WARNING!
Strictly observe the following when shipping the instrument:
All instruments delivered to WIKA must be free from any kind of hazardous
substances (acids, bases, solutions, etc.).
When returning the instrument, use the original packaging or a suitable transport
packaging.

WIKA UPT-20 Specifications

General

Brand	WIKA
Model	UPT-20
Category	Transmitter
Language	English