11
WIKA operating instructions process transmitter, model UPT-2x
14111166.02 04/2015 EN/DE
EN
3. Safety
3.4 Risks in hazardous areas
Observe the information given in the type examination certicate and the country-specic
regulations for installation and use in hazardous areas (e.g. IEC 60079-14, NEC, CEC). If
this is not observed, serious injuries and damage could occur.
Do not commission any damaged instruments within hazardous areas. Damaged instru-
ments cannot reliably guarantee any explosion protection. Obvious damage must be
reported immediately.
3.5 Handling of hazardous media
For hazardous media such as oxygen, acetylene, ammable or toxic gases and liquids
and refrigeration plants, compressors, etc., in addition to all standard regulations, the
appropriate existing codes or regulations must also be followed.
Residual media in the dismounted process transmitter can result in a risk to personnel,
the environment and equipment. Take sucient precautionary measures.
3.6 Labelling, safety marks
Product label
Pin assignment
Model
Permissible ambient temperature
Power supply
Model code
Approval ratings
Output signal
Date of manufacture YYYY-MM
Measuring range
S# Serial no.
P# Product no.
To Next Page
Loading...
Need help?
General
