Willys MB - Water Pump Inspection and Repair

9
SCREW
I
Figure 18 - Checking Connecting Rod AJinement for Twist, using
Aliner (4 I -A- 135)
pulley from the water pump body. Press the water pump pulley off
the water pump bearing and shaft assembly.
b. Cleaning. Clean all parts thoroughly in dry-cleaning solvent.
c. Inspection and Repair.
(1) WATER PUMP BODY (fig. 17). A cracked or damaged water
pump body must be replaced.
(2) WATER PUMP IMPELLER (fig. 17). A water pump impeller
that is cracked or that has a broken fin must be replaced
(3) WATER PUMP PULLEY (fig. 17). A distorted or damaged
water pump pulley must be replaced.
27