I
I I
RA PD 28696
and
out on the flywheel with a dial gage. If the run-out exceeds 0.008
inch at the outer edge, the flywheel or crankshaft flange must be
refaced.
Hold the clutch disk
on the flywheel, and install a clutch pilot tool in the flywheel and the
disk. Hold the pressure plate on the flywheel and install, but do not
tighten, six lock washers and cap screws (fig. 39). Tighten the six
cap screws evenly to prevent bending the pressure plate frame. Re-
move the clutch pilot.
Place a gasket and the engine front
plate on the engine? and install the three cap screws. Turn the crank-
shaft until No. 1 piston is at top center (fig. 38). Install the camshaft
49
To Next Page
Loading...
