Wilo Control EC-L1 Series - Page 38

en
38 Installation and operating instructions • Wilo-Control EC-L • Ed.04/2022-09
Fig.50: Menu 5.65
Menu no. 5.65
Software version: All
Description Automatic resetting of error “Dry run”
Value range on, off
Factory setting on
Explanation If the fill level is over the dry run level again, the error message
“dry run” is automatically reset.
• on = function activated
• off = function deactivated
Fig.51: Menu 5.66
Menu no. 5.66
Software version: All
Description Integrated buzzer On/Off
Value range off, error
Factory setting off
Explanation Switching the buzzer on or off:
• off = buzzer off
• error = buzzer on
NOTICE!Alarm in the event of interrupted power supply: To
switch off the internal buzzer if there is a built-in re-
chargeable battery, remove the battery!
Fig.52: Menu 5.67
Menu no. 5.67
Software version: All
Description Output (24V=, max. 4VA) On/Off for an external signalling unit
Value range off, error
Factory setting off
Explanation Separate output to switch an external alarm signal on or off:
• off = output deactivated
• error = output activated
Fig.53: Menu 5.68
Menu no. 5.68
Software version: All
Description Mains connection rotating field monitoring On/Off
Value range on, off
Factory setting on
Explanation Integrated rotating field monitoring for the mains connection.
If no clockwise rotating field is present, an error message oc-
curs.
• off = rotating field monitoring deactivated
• on = rotating field monitoring activated
NOTICE!When operating the switchgear via a single-phase
current connection, switch off this function!