36
WILO SE 04/2017
English
6Operation
6.1 Resetting the power consumption meter
• Press the operating knob (8) for 10 seconds when in
downtime status.
The meter reading flashes 5 times before resetting to
zero.
6.2 Resetting the settings to the factory settings
• Press the operating knob (8) for 20 seconds when in
downtime status.
All LED segments light up for 2 seconds. The pump is
then reset to its factory settings and the power con-
sumption meter is at zero.
7 Decommissioning
Shutting down
the pump
Shut down the pump immediately in case of damage to
the connecting cable or other electrical components.
• Disconnect the pump from the power supply.
• Contact Wilo customer service or a qualified specialist
technician.
8Service
Cleaning • Carefully remove soiling from the pump on a regular
basis using a dry duster.
• Never use liquids or aggressive cleaning agents.
Note: All settings and displays are retained if the
power supply is interrupted.
To Next Page
Loading...
