Safety
and Recommendations
ffi
WARNING:
Connecting the
Signal
Booster
directly
to the cell
phone with use
of
an adapter
will
damage the
cell
phone.
ffi
WARNING:
Use
only the power
supply
provided in this package. Use
of
a
non-Wilson Electronics
product may damage
your equipment.
ffi WARNING: To
uphold compliance
with network protection standards, all
active
wireless
devices must maintain at
least
18"
of
separation distance from
mobile
inside antennas, 4'
of
separation distance from desktop antennas and
6'
of
separation distance from
Panel
and Dome antennas.
ffi WARNING: The
Signal
Booster unit is designed for use in an indoor, temperature-controlled environment
(less
than
150
degrees Fahrenheit).
It
is not intended for use in attics
or
similar locations
subject to temperatures in excess
of
that range.
ffi
RF SAFETY
WARNING:
Any antenna used with this device must be
located
at
least 8 inches from
all
persons. The FCC
requires that a
cell
phone with
cradle
attached may
only
be used with the
cradle
mounted as illustrated
in
this
installation
guide. A
cell
phone
held
near the ear must be without the
cradle
attached.
This
is
a
CONSUMER
device.
BEFORE
USE,
you
MUST
REGISTER
THIS
DEVICE
with your
wireless
provider
and
have
your
provider's
consent.
Most
wireless
providers
consent
to
the
use
of
signal
boosters.
Some
providers
may
not consent
to
the
use
of
this
device
on
their network.
If
you
are
unsure,
contact
your
provider.
You
MUST
operate this device with
approved
antennas
and
cables
as
specified
by
the
manufacturer.
Antennas
MUST
be
installed
at
least
20
em
(8
inches)
from
any
person.
You
MUST
cease
operating this
device
immediately
if
requested
by
the
FCC
or
a
licensed
wireless
service
provider.
WARNING.
E911
location information
may
not
be
provided
or
may
be
inaccurate for
calls
served
by
using
this
device.
This device
complies
with
Part
15
of
FCC
rules. Operation is subject to
two
conditions: (1) This device
may
not cause
harmful
interference, and (2) this device must accept any interference received,
including
interference
that
may cause
undesired operation. Changes
or
modifications not
expressly
approved by
Wilson
Electronics
could
void the authority to
operate this equipment.
7
Need
help?
~
www.
WilsonE/ectronics.com
~
0
Tech
Support
866-294-1660
Mon.-
Fri
. Hours: 7
am
to 6
pm
MST
To Next Page
Loading...
