30-Day
Money-Back
Guarantee
All Wilson
Electronics
products are protected by Wilson
Electronics
30-day
money-back guarantee.
If
for
any reason the
performance
of
any product is not acceptable, simply return the product directly to the
reseller with a dated
proof
of
purchase.
2-Year
Warranty
Wilson Electronics Signal Boosters are warranted for two (2) years against defects in workmanship and/or
materials. Warranty cases may be resolved by returning the product directly to the reseller with a dated proof
of
purchase.
Signal Boosters may also be returned directly to the manufacturer at the consumer's expense, with a dated
proof
of
purchase and a Returned Material Authorization (RMA) number supplied by Wilson Electronics.
Wilson Electronics shall, at its option, either repair
or
replace the product. Wilson Electronics will pay for
delivery
of
the repaired or replaced product back to the original consumer if located within the continental U.S.
This warranty does not apply to any Signal Boosters determined by Wilson Electronics to have been subjected
to misuse, abuse, neglect,
or
mishandling that alters
or
damages physical
or
electronic properties.
Failure to use a surge protected AC Power Strip with at least a 1000 Joule rating will void your warranty.
RMA numbers may be obtained by contacting Technical Support at 866-294-1660.
Signal Booster Specifications
Sleek
Model
Number
460006
Connectors SMA-Female
Antenna Impedance 50 Ohms
Frequency
82~94
MHz/1850-1990 MHz
800 IlHz 1900 IlHz
3
Power
output
for
single
cell
phone
(dBm)
Uplink
Downlink
22.9
-28.0
25.2
-29.1
Noise Figure (typical downlink/uplink)
3dB
nominal
Isolation
>40dB
Power
Requirements
5.5 V 1A
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without factory
reprogramming
or
disabling the hardware. The Signal Booster will amplify, but not alter incoming and outgoing signals
in
order to increase
coverage
of
authorized frequency bands only. If the Signal Booster is not
in
use for five minutes, it will reduce gain until a signal
is
detected.
If
a detected signal is too high
in
a frequency band,
or
if the Signal Booster detects an oscillation, the Signal Booster will automatically tum the
power off
on
that band. For a detected oscillation the Signal Booster will automatically resume normal operation after a minimum of 1 minute.
After 5 (five) such automatic restarts, any problematic bands are permanently shut off until the
Signal Booster has been manually restarted by
momentarily removing power from the
Signal Booster. Noise power, gain, and linearity are maintained by the Signal Booster's microprocessor.
Disclaimer:
The
information provided by Wilson Electronics, LLC is believed to
be
complete
and accurate. However,
no
responsibility
is
assumed
by
Wilson Electronics, LLC
for
any
business
or
personal losses arising
from
its use,
or
for
any infringements
of
patents
or
other
rights
of
third parties
that
may
result from its use.
Copyright©
2014 Wilson Electronics, LLC All rights reserved.
U.S. Patent Nos
.-
7,221,967; 7,729,669; 7,486,929; 7,409,186; 7,783,318; 8,583,034; 8,583,033; 7,684,838;
0626,953
; 8,473,018
~Wilson
Electronics
3301
East Deseret Drive.
St.
George,
UT
84
790
web:
www.WilsonEiectronics.com 1 email: tech@wilsonelectronics.com
phone: 866-294-1660 I
local:
435-673-5021 I fax: 435-656-2432
You(D
El
IJ
111283
Revv'
01
21
14
To Next Page
Loading...
