SIGNALBOOST™ DT Installation Instructions
2
Welcome to the Wilson Electronics Family of Products!
Thank you for purchasing the Wilson SIGNALBOOST™ DT amplifi er system. You are just minutes away
from enjoying improved performance from your cellular phone and/or laptop data card. When installed
properly, the SIGNALBOOST™ DT will signifi cantly reduce dropped calls and improve both voice and
data signal quality. By taking a few minutes to read and follow the simple instructions in this guide, you
will get the most out of your new amplifi er system. If you have questions during or after installation, please
don’t hesitate to contact a member of our Technical Support team by phone (866-294-1660 or 435-673-
5021) or email (tech@wilsonelectronics.com). We’re here to help!
Inside this Package:
SIGNALBOOST™
DT Amplifi er
On-board
Antenna
Antenna
and Cradle
AC Power
Supply
Coaxial Cable
(50 ft.)
Amplifi er
Wall Bracket
Window-Mount
(Packet A)
Wall-Mount
(Packet B)
Pole-Mount
(Packet C)
Tools Required for Installation:
Depending on your particular installation, you will need the following tools:
• Window-mount - No additional tools needed
• Wall-mount - Drill and 3/16-inch bit, Phillips-head screwdriver
• Pole-mount - 1/4-inch open-end wrench or adjustable wrench
To Next Page