The unit must never run dry or be operated with the suction line fully closed.
The device must not be used for the operation of swimming pools.
The device must not be installed in the drinking water circuit.
Warning:
Read all safety instructions and instructions. Failure to follow the safety precautions and instructions
may result in electric shock, fire and/or serious injury. Keep all safety information and instructions in a
safe place for future reference.
Durability
The maximum temperature of the pumped liquid should not exceed +35°C in continuous operation.
Avoid pumping aggressive liquids (acids, lyes, silo leach etc.) as well as liquids containing abrasive
substances (e.g. sand).
Electrical Connection
The electrical connection is made at a 230 V ~ 50 Hz socket outlet with earthing contact. Fuse protec-
tion at least 6 Ampere.
The motor is protected against overload or blocking by the built-in thermal motor protection. In case of
overheating, the overheating protection of the motor automatically switches the pump off and after
cooling down the pump switches itself on again automatically.
Power Supply
The pond pump you have purchased is already equipped with a safety plug. The pump is intended for
connection to a 230 V~50 Hz socket. Make sure that the socket is sufficiently fused (min. 6A) and in
order. Insert the pump plug into the socket so that the pump is ready for operation.
© by WilTec Wildanger Technik GmbH Seite 14
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
To Next Page
Loading...
Need help?
General
