Hibernation
1) Take the pump out of the water and disconnect it from the mains.
2) Clean the pump as described in the manual.
3) Check the pump for damage, e.g. cracks in the housing.
4) Please store the pump under frost-free conditions, if possible in a container with water.
Maintenance and Cleaning
Figure No.__:
1) Adjust the flow velocity using the blue regulator.
2) Open the filter housing by turning an arrow and then pulling it off.
3) Press the blue switch to open the motor housing.
4) Hold the blue switch firmly and turn the flap on the motor housing in the direction of the arrow.
5) Pull the impeller and pump shaft out of the casing to clean them.
6) Make sure the O-ring is properly reassembled before reassembling the pump.
© by WilTec Wildanger Technik GmbH Seite 17
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
To Next Page
Loading...
Need help?
General
