Overload Protection
The pump has an integrated overheating protection. The pump must cool down for a while after being
switched off by the overheat protection before being able to operate again. If it does not start by itself,
perform the following checks:
Could the pump cool down sufficiently after switching off due to the overheating protection?
Is the water supply sufficient? > Improve water supply!
Is there dirt in the pump casing? > Carry out the following cleaning!
Hose or pipe blocked? > Clean it!
Tube kinked, too long? > Check, replace, shorten!
Pump Design
1 Regulator* 4 Rotor Intake 7 Engine Housing 10 Outlet Screw
2 Filter Basket 5 O-Ring 8 Gasket 11 Outlet
3 Pump Casing 6 Bearing 9 Outlet
*Optional: The models CTP-2800 to CTP-8000 are adjustable. The models CTP-10000 to CTP 16000
are not adjustable.
© by WilTec Wildanger Technik GmbH Seite 16
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
To Next Page
Loading...
