Installation
Please position the pump under water and make sure that no water gets into the socket.
Figure 1)
The pump is installed as follows: either in a fixed po-
sition with fixed piping or in a fixed position with flexi-
ble piping.
Use as submerged pump
(See figure 1)
Immerse the pump completely in the pond so that it
fills with water. To protect the pump from clogging,
place the pump above the pond sludge. The pump is
started by plugging in the mains plug.
Commissioning
After you have read these installation and operating instructions carefully, you can put your new pump
into operation by observing the following points:
Check that the pressure line is properly installed.
Make sure that the electrical connection is 230V~50Hz.
Check that the outlet is in proper condition.
Make sure that moisture or water never gets to the mains connection.
Place the pump below the water surface.
Avoid the pump from running dry.
Never operate the pump without a filter basket, which protects the pump from dirt that might clog
the pump.
Maintenance Instructions
The pond motor pump is a proven quality product that is subjected to strict final inspections.
However, for a long service life and uninterrupted operation, we recommend regular inspection and
cleaning.
In order to ensure proper functioning of the pump, it is necessary to clean it regularly. We recommend
a weekly cleaning of the pump.
© by WilTec Wildanger Technik GmbH Seite 15
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
To Next Page
Loading...
Need help?
General
