BEFORE YOU START
9
UNPACKING THE CHOP SAW
WARNING:
To avoid injury:
• Do not plug the power cord into the power source during
unpacking or assembly.
• If any part is missing or damaged, do not connect the saw to the
power source until the missing or damaged part is replaced and
assembly is complete.
• Avoid fire and toxic reaction. Never use gasoline, naphtha,
acetone, lacquer, thinner or any volatile solvents to clean the
saw.
1. Carefully unpack the abrasive chop saw and all its
components.
2. Inspect the contents and compare to the list below.
1 14" abrasive chop saw
2 Vise handle knob
3 Threaded bolt and nut
4 Adjusting wrench
Figure 2
1
2
3
4
To Next Page
