Need help?Do you have a question about the Wilton 8020 and is the answer not in the manual?
Guidelines for safe electrical connections and grounding of the band saw.
Recommended wire sizes for branch circuits to ensure proper voltage delivery.
Crucial safety steps for operating the band saw system effectively.
Overview of band saw components and initial installation procedures.
Information on connecting the band saw to facility electrical power.
Details on the location and function of the band saw's operating controls.
Description of the optional blade welder and its capabilities.
Identification of the key components and features of the blade welder unit.
Step-by-step guide for using the blade welder to cut, weld, and anneal blades.
Procedure for adjusting the band saw blade speed for different materials.
Guidance on choosing the appropriate saw blade for various materials.
Instructions for cleaning the chip pan and lubricating the air pump.
Step-by-step guide for replacing the band saw blade.
Procedure for replacing the drive belts for the gearbox.
Instructions for replacing drive belts for the motor and air compressor.
Steps to replace the vari-speed drive belts on the band saw.
Procedure for replacing the upper and lower blade guides.
Instructions for replacing the chip brush assembly.
Procedure for adjusting the band saw blade to track correctly.
How to adjust the tilt of the work table for different cutting angles.
To Next Page
General
