- Misuse of this machine can cause serious injury.
- For safety, machine must be set up, used and
serviced properly.
- Read, understand and follow instructions in the
Operating Instructions and Parts Manual which was
shipped with your machine.
When Setting up Machine:
- Always avoid using machine in damp or poorly
lighted work areas.
- Always be sure the machine support is securely
anchored to the floor or the work bench.
When Using Machine:
- Always wear safety glasses with side shields (See
ANSI Z87.1)
- Never wear loose clothing orjewelry.
- Never overreach - you may slip and fall.
When Servicing Machine:
- Always disconnect the machine from its electrical
supply while servicing.
- Always follow instructions in Operating Instructions
and Parts Manual when changing accessory tools
or parts.
- Never modify the machine without consulting
Wilton Corporation.
You - the Stationary Power Tool User -
Hold the Key to Safety.
Read and follow these simple rules for best results
and full benefits from your machine. Used properly,
Wilton's machinery is among the best in design and
safety. However, any machine used improperly can
be rendered inefficient and unsafe. It is absolutely
mandatory that those who use our products be
properly trained in how to use them correctly. They
should read and understand the Operating Instructions
and Parts Manual as well as all labels affixed to the
machine. Failure in following all of these warnings
can cause serious injuries.
Machinery General Safety Warnings
1. Alwayswear protective eye wear when operating 8.
machinery. Eye wear shall be impact resistant,
protective safety glasses with side shieldswhich
comply with ANSI Z87.1 specifications. Use of
eye wear which does not comply with ANSIZ87.1
specifications could result in severe injury from
breakage of eye protection.
2. Wear proper apparel. No loose clothing or
jewelry which can get caught in moving parts.
Rubbersoled footwear isrecommendedfor
best footing.
3. Do not overreach. Failureto maintain proper
working position can cause you to fall intothe
machine or cause your clothing to get caught
pulling you intothe machine.
4. Keep guards in place and in proper working
order. Do not operate the machine with
guardsremoved.
5. Avoid dangerousworking environments. Do not
use stationary machine tools inwet or damp
locations. Keepwork areas clean and well lit.
6. Avoid accidental starts by being sure the start
switch is OFF before plugging inthe machine.
7. Never leavethe machine runningwhile unat-
tended. Machineshallbeshutoffwheneverit
is not in operation.
Disconnect electrical power before servicing.
Whenever changing accessories or general
maintenance is done on the machine, electrical
powerto the machine must be disconnected
before work is done.
9. Maintainall machinetools with care. Follow all
maintenance instructionsfor lubricatingand the
changingof accessories. No attempt shall be
made to modifyor have makeshift repairsdone to
the machine. This not only voids the warranty but
also rendersthe machine unsafe.
10. Machinery must be anchoredto the floor.
11. Securework. Use clamps or a vise to hold work,
when practical. It is safer than using your hands
and itfrees both handsto operate the machine.
12. Never brush away chips while the machine is in
operation.
13. Keepwork area clean. Cluttered areas invite
accidents.
14. Removeadjusting keysandwrenches before
turning machineon.
15. Usethe right tool. Don't force a tool or attach-
ment to do a job it was not designed for.
16. Useonly recommendedaccessoriesand follow
manufacturersinstructionspertainingtothem.
17. Keep hands in sight and clear of all moving parts
5
To Next Page
Loading...
