- Make sure the wall outlet is not defective, by plugging something else
- (e.g., a lamp) into the outlet to check it.
Internal or External Display-Related Problems:
Problem: There is a blank display, no beeps were heard, and the LCD indicator is blank.
Action: - If you are running on AC power, make sure the adapter is plugged in and the green
power indicator is lit.
- If you are running on battery power, make sure a charged battery is installed in your system.
- If you are using a docking station, unplug your WinBookXP from the dock and retry.
Problem: There is a blank display, no beeps were heard, and the LCD indicator panel is
active.
Action: - Make sure the WinBookXP power switch is turned on.
- If using battery power, make sure battery is charged.
- If using AC power, see that AC power indicator is on.
- Unplug all external connections except for the AC power and try again.
- If you are using a docking station, unplug WinBookXP from dock and retry.
Problem: The power switch is on, but there is a blank display, no beeps, and the LCD
indicator panel is active.
Action: - System is in suspend, check to see if the suspend icon is displayed on the indicator
panel.
- Press suspend switch to reactivate.
- If you are using a docking station, unplug WinBookXP from dock and retry.
- External display may be selected. Press ‘Fn’ + ‘F6’ to set display to Simulscan mode.
Problem: The display is blank and a single beep was hear.
Action: - Check to make sure brightness and contrast controls are at it’s midpoint settings.
- Check that the active display option has been set to LCD or Simulscan:
A. Press the ‘Fn’ + ‘F10’ keys simultaneously to change the active display type setting;
B. Press ‘CTRL’ + ‘ALT’ + ‘S’ to enter setup screen to select display type.
C. Press ‘Fn’ + ‘F6’ to force display to Simulscan mode.
To Next Page
Loading...