Winbook XP - Page 67

Problem: There is a blank screen and a series of beeps, or a long continuous beep.
Action: - If an option has just been installed remove the newly installed option:
A. Check to be sure memory expansion card is correctly installed:
B. Check to be sure audio card is correctly installed:
C. Check to be sure modem is correctly installed.
- If you are using a docking station, unplug WinBookXP from dock and try again.
- If failure persists, call the Service Center listed on the “Read-Me-First” sheet that came with
the WinBook.
Problem: Display is on, but system will not display any messages (blank screen).
Action: - If an option has just been installed, remove newly installed option:
A. Check to be sure memory expansion card is correctly installed;
B. Check to be sure audio card is correctly installed;
C. Check to be sure modem is correctly installed.
- If you are using a docking station, unplug WinBookXP from dock and try again.
- If failure persists, call the Service Center listed on the “Read-Me-First” sheet that came with
the WinBook.
Problem: The screen is not readable.
Action: - If an option has just bee installed, remove newly installed option:
A. Check to be sure memory expansion card is correctly installed;
B. Check to be sure audio card is correctly installed;
C. Check to be sure modem is correctly installed.
- If failure persists, call the Service Center listed on the “Read-Me-First” sheet that came with
the WinBook.
Problem: Incorrect image is on display.
Action: - Be sure operating system is installed correctly.
- Boot system from DOS “Boot” diskette to see if problem goes away.
- If a new hard drive has been installed, remove it and insert old one.
- When using LCD display, be sure S/W has correct driver (VGA) installed.