What to do if the Wincor Nixdorf TH210 LED blinks five times?
If the Wincor Nixdorf Printer LED blinks five times and then remains off, it could be due to the top cover being open or the paper being out. Ensure the cover is properly closed and load a new paper roll.
Why is the print light or spotty on my Wincor Nixdorf Printer?
If your Wincor Nixdorf Printer produces receipts with light or spotty print, the issue might stem from the paper roll being loaded incorrectly, a dirty thermal printhead, or variations in the paper itself. Check that the paper is loaded properly. If that doesn't solve the problem, try using the recommended thermal paper roll. For monochrome printers, you can also increase the print density in the 'Set Hardware Options' of the printer Configuration Menu to 110% or 120% as needed.
What to do if the receipt does not come out all the way from Wincor Nixdorf TH210?
If the receipt does not come out all the way from your Wincor Nixdorf Printer, it is likely due to a paper jam. Open the top cover, inspect the knife, and clear any jammed paper.
Why does my Wincor Nixdorf TH210 Printer stop printing in the middle of a receipt?
If your Wincor Nixdorf Printer starts printing but stops mid-receipt, this is likely caused by a paper jam. To resolve this, open the top cover, inspect the knife, and clear any jammed paper.
What to do if the receipt is not cut by Wincor Nixdorf TH210?
If the receipt is not being cut by your Wincor Nixdorf Printer, it's probably because of a paper jam. Open the top cover, inspect the knife, and clear any obstructions.
What does it mean if the LED blinks quick and steady on Wincor Nixdorf Printer?
If the LED on your Wincor Nixdorf Printer blinks quickly and steadily when you power it up, it indicates invalid firmware. You should load new firmware.
Why is there a colored stripe on the receipt from my Wincor Nixdorf TH210?
If your Wincor Nixdorf Printer produces receipts with a colored stripe, it indicates that the paper is low. Change the paper.
What does it mean if the LED blinks once on Wincor Nixdorf TH210?
If the LED on your Wincor Nixdorf Printer blinks once and then remains off, and the knife is unable to home, stop using the printer. Alternatively, contact your authorized service representative.
Why does the LED blink twice and stay on with my Wincor Nixdorf Printer?
If the LED on your Wincor Nixdorf Printer blinks twice and then stays on, it could be due to low voltage. Allow the voltage to recover, or try a new power supply. If this occurs on power up, contact your authorized service representative.
Why does the LED blink three times and stay on with my Wincor Nixdorf TH210 Printer?
If the LED on your Wincor Nixdorf Printer blinks three times and then stays on, it could be due to high voltage. Allow the voltage to recover, or try a new power supply. If this occurs on power up, contact your authorized service representative.
General| Printing Method | Direct Thermal |
|---|---|
| Print Width | 72 mm |
| Print Resolution | 203 dpi |
| Paper Width | 80 mm |
| Paper Roll Diameter | Up to 83 mm |
| Power Supply | 24 VDC |
| Type | Receipt printer |
| Connectivity | USB, RS232, Ethernet |
To Next Page
