1. Utilize a 5mm hex wrench to initially tighten the screw at position ①.
2. Loosen the screw at ② and remove the gland.
3. Securely fasten the handlebar and tighten the screws using an Allen wrench.
4. Rotate clockwise to tighten.
Installing The Handlebars
1. Please loosen the screws that connect the cushion to the shock absorber.
2. Pull the seat cushion upward to unfold it.
3. Align the screw holes and use the installation hex wrench to tighten the screws.
4. Turn the screw clockwise to tighten.
Install Seat Shock Absorbers
①
②
To Next Page
Loading...