42
Maintenance
PROBLEM CAUSE SOLUTION
Vacuum motor does not run, or
runs slowly
Faulty vacuum circuit or switch Check wires & connections
Worn vacuum motor brushes Replace brushes, check commutator
Vacuum circuit breaker tripped Reset circuit breaker
Poor burnishing performance Debris caught in pad Remove debris or change pad
Worn pad Replace pad or flip pad
Improper pad used
Contact equipment or application
specialists
Low battery charge Charge batteries
Burnisher motor does not run, or
runs slowly
Circuit breaker tripped Reset circuit beaker
Low battery charge Charge battery
Faulty brush circuit or motor Check wires, connections and motor
Worn brush motor brushes Replace brushes, check commutator
Deck does not go down Actuator circuit breaker tripped Reset actuator circuit breaker
86356230 Chariot iGloss
To Next Page
Loading...
