Windsor CLP - Operating the Clipper; Setting Brush Height; Critical Safety: Flammable Substances

NOTE: Vacuum the carpet and make sure it is cleared of
surface debris before cleaning with the CLIPPER.
NOTE: Attach strain relief/cord retainer to the power cord.
1.
Make a loop in power cord
approximately 12” from twist
lock receptacle end.
2.
Slide cord loop through slot in
retainer arm. Pull slack cord back
through slot to secure. Attach
retainer to handle.
For larger unobstructed areas, reverse the handle and
use the machine’s brush assisted propelling motion.
q
4.
Adjust brush to proper cleaning position by using
lever located at lower back of the motor housing.
Start at No. 1 “new brush” (black) position. If more
carpet pile agitation is desired, lower brush setting
one position at a time. (Fig. 1)
A
Recovery tank drain hose
:
Vacuum recovery hose
Vacuum hose
D
Solution tank drain hose
E
Auxiliary tool outlet nipple
Solution directional
G Brush height adjustment lever
5.
Check to be sure solution dlrectional valve Is set
on “Carpet Spray” position. (Fig. 3)
VAC
SWITCH
CONTINUOUS
PUMP
SWITCH
BRUSH
SWITCH
I BRUSH
RESET
I VAC
4
98032 7/l/97