22
Operations
Troubleshooting
Problem Cause Solution
Worn brush bearings
Squealing or grinding sound in
brush housing.
Replace bearings.
Carpet not getting clean Severe soil conditions
Make several passes at right angles to each other.
Use a pre-spray.
Carpet too wet Worn spray jet Replace spray jet which is producing a fine mist.
Carpet not getting wet
Solution filter screen clogged.
Clean solution filter screen located inside lower
tank.
Spray jet clogged.
Clean or replace jet. Do not use a wire to clean
jet. Damaged jet will cause over-saturation.
Pump not running.
Check for and correct any loose wires. Repair or
replace.
Faulty solution switch. Replace switch in handle.
86401460 Operator’s Manual - Mini Carpet Extractor
To Next Page
Loading...
