To Next PageTo Next PageHow to troubleshoot a Windsor Saber Blade 16 Scrubber that will not start?
If your Windsor Scrubber isn't starting, begin by verifying that the mains plug is securely connected. Also, ensure that the socket fuse rating is adequate for the appliance's power requirements.
What to do if my Windsor Saber Blade 16 has insufficient vacuum performance?
If your Windsor Scrubber has insufficient vacuum performance, first empty the recovery tank. Then, check that the solution tank is properly seated on the wastewater reservoir. Inspect the seals on the solution tank, and clean them if needed. Also, clean the seals between the appliance and the recovery tank, ensure they are tight, and replace if necessary. Clean the lint trap and the squeegee blades, replacing them if required. Clear any blockages in the suction channel and check the vacuum bar for plugs, removing them if found.
How to improve the cleaning result of my Windsor Scrubber?
If your Windsor Scrubber isn't cleaning well enough, try increasing the brush contact pressure. Inspect the brushes for wear and replace them if necessary. Also, ensure you're using brush rollers that are appropriate for the type of dirt and floor covering you're cleaning.
What causes the brushes to not turn on my Windsor Saber Blade 16 Scrubber?
If the brushes on your Windsor Scrubber aren't turning, check for any foreign objects blocking them and remove any obstructions. You might also need to reduce the contact pressure. If an overcurrent protective switch was triggered, the operation will resume automatically after one minute.
Why is my Windsor Scrubber dispensing insufficient water?
If your Windsor Scrubber isn't dispensing enough water, start by checking the fresh water level and refilling the tank if it's low. Clean the ball valve in the solution tank. Ensure that the solution tank is correctly seated on the appliance. Also, inspect the filter in the solution tank for clogs and clean it if necessary. Finally, check the hoses for any blockages and clean them if needed.
Why does my Windsor Saber Blade 16 Scrubber vibrate?
If your Windsor Scrubber is vibrating, it could be due to deformed brush rollers. This can happen if they weren't unloaded by tilting the slider vertically when parking the appliance. In this case, replace the brush rollers.
Guidance on proper grounding of the appliance to prevent electric shock.
Rules and guidelines for safe operation of the appliance.
Guidelines for maintaining the unit and reporting issues.
Procedures for proper maintenance and repairs.
Precautions and standards for fire prevention during operation.
Describes the intended use and capabilities of the appliance.
Details the correct applications and limitations of the appliance.
Information on recycling packaging and disposing of old units.
Identifies and labels key parts of the machine.
Step-by-step guide for attaching the pushing handle.
Instructions for fitting the transport wheels to the appliance.
Guidance on how to install the brushes before initial use.
Instructions on how to fill the tank with water and detergent.
Steps for moving the appliance to the work area.
How to set the correct pressure for the brush rollers.
Guidance on connecting the appliance to the power supply.
Steps for performing wet cleaning with the appliance.
Instructions for using the appliance for polishing tasks.
Procedures for safely turning off and disconnecting the machine.
Steps to safely drain the fresh water/detergent tank.
Steps to empty the dirty water tank.
Guidelines for safely transporting the machine.
Overview of regular maintenance tasks.
Instructions for removing and installing the squeegee.
Guide on how to change the brush rollers.
Information on service contracts for reliable operation.
Measures to protect the appliance from freezing.
Table listing common errors and their solutions.
List of available accessories with order numbers.
Guidelines for using approved spare parts.
Details of the warranty for new machines.
Conditions under which the warranty is void.
General