Windsor Saber Cutter SC264

Questions and Answers

C
cgeorgeAug 9, 2025
Why is there poor or no water pick-up with my Windsor Saber Cutter SC264?
- R
  Raymond LewisAug 9, 2025
  Poor or no water pick-up in your Windsor Scrubber can stem from several causes. The squeegee might be out of adjustment, so try adjusting it. Debris caught on the squeegee can also be the culprit; remove any obstructions. Check for worn squeegee blades and rotate or replace them if necessary. Ensure the vacuum hose isn't clogged by clearing any obstructions. Also, verify that the vacuum hose is properly connected to both the squeegee and recovery tank, reconnecting if needed. If the vacuum hose is damaged, replace it. Make sure the recovery tank is sealed correctly by placing the dome securely and replacing any damaged gaskets. Lastly, excessive foam in the recovery tank can hinder pick-up; empty the tank and consider using less detergent, a different detergent, or a defoamer.
A
alicia86Aug 16, 2025
What to do if the vacuum motor on my Windsor Scrubber doesn't run or runs slowly?
- L
  Larry WoodAug 16, 2025
  If the vacuum motor on your Windsor Scrubber isn't running or is running slowly, there are a few things to check. First, ensure the recovery tank isn't full by draining it. A dirty recovery tank float system can also cause this issue, so clean it thoroughly. Check if the circuit breaker has tripped and reset it if necessary. Inspect the motor wires and connections for any looseness. If the vacuum switch is faulty, it will need to be replaced. Finally, worn vacuum motor brushes can be the problem; replace them and check the commutator.
R
Robert HarrisAug 23, 2025
How to improve poor scrubbing performance on my Windsor Scrubber?
- S
  Shane SmithAug 23, 2025
  If you're experiencing poor scrubbing performance with your Windsor Scrubber, consider these potential causes. Start by checking the scrub brushes for any debris and remove it. If the brushes or pads are worn, replace them. Ensure that you are using the correct detergent, brush, or pad. Also, check the scrub brush down pressure and increase it if it's too low. Lastly, verify that the batteries are fully charged.
D
Donna WilsonAug 31, 2025
What to do if brush motors on my Windsor Saber Cutter SC264 do not run or run slowly?
- C
  Charlene ShawAug 31, 2025
  If the brush motors on your Windsor Scrubber aren't running or are running slowly, here are some things to investigate: * Check if any circuit breakers have tripped and reset them. * Inspect the motor wires and connections for any looseness. * If the brush motor contactor is faulty, replace it. * Worn brush motor brushes can also cause this; replace the brushes and check the commutator.