Windsor Chariot 3 - User Manual

Questions and Answers

R
robingibbsJul 29, 2025
What to do if my Windsor Scrubber has poor water pickup?
- B
  brookesandovalJul 30, 2025
  If your Windsor Scrubber isn't picking up water effectively, there could be several reasons. Start by checking the squeegee for any debris and remove it. Inspect the squeegee blades for wear; rotate or replace them if needed. Ensure the vacuum hose isn't clogged by clearing any obstructions. Verify the vacuum hose is properly connected to both the squeegee and the recovery tank dome. A dirty recovery tank float system can also cause issues, so clean it thoroughly. Make sure the recovery tank is sealed correctly by latching the lid and replacing any damaged gaskets. If the tank is full, the float-ball shut-off might be engaged, so empty the recovery tank. Finally, if foam is filling the recovery tank, empty it and consider using less detergent, a different detergent, or a defoamer.
S
Susan ChambersAug 4, 2025
What to do if my Windsor Scrubber has no power?
- M
  Mary FlemingAug 5, 2025
  If your Windsor Scrubber has no power, begin by checking all battery cable connections to ensure they are secure. Verify that the emergency shut-off is not activated; if it is, reset it. Inspect the battery cables for corrosion and clean them if necessary. A faulty key switch could also be the culprit, requiring replacement. Ensure the on-board charger is unplugged and stowed. Finally, check the main circuit breaker and reset it if it has tripped.
D
Darren JohnsonAug 10, 2025
Why does my Windsor Scrubber have little or no propel?
- K
  kenneth05Aug 10, 2025
  If your Windsor Scrubber has little or no propel, the following could be the reasons why: * Low battery charge: Charge the batteries. * Machine turned on with pedal not in neutral position: Allow pedal to return to neutral, then restart. * Tripped circuit breaker: Reset the circuit breaker. * Wheels spin: Decrease brush pressure. * Controller overheated: Allow a cool down period. * Loose motor connection: Check wires and connections from controller to motor. * Faulty throttle circuit or potentiometer: Check wires and connections from and potentiometer resistance. * Faulty drive reset circuit or switch: Check wires, connections and switch. * Faulty platform circuit or switch: Check wires, connections and switch.
J
Joseph WillisAug 16, 2025
How to fix a Windsor Scrubber that does not change speeds?
- R
  Robert StoneAug 17, 2025
  If your Windsor Scrubber isn't changing speeds, the issue might stem from a faulty speed control circuit or switch. Inspect the wires and connections to identify any potential problems.
T
Theresa TaylorAug 23, 2025
What to do if my Windsor Scrubber only has forward or reverse speed?
- D
  davidnelsonAug 23, 2025
  If your Windsor Scrubber is only operating in forward or reverse, there may be a faulty forward/reverse circuit. Check the wires and connections.