Windsor chariot iScrub 20 CSXC20

Questions and Answers

J
joelmitchellAug 23, 2025
Why is the brush motor not running or running slowly on my Windsor chariot iScrub 20 CSXC20?
- J
  James SalazarAug 23, 2025
  If your Windsor Scrubber's brush motor doesn't run or runs slowly, it could be due to a few reasons. The circuit breaker might have tripped; try resetting it. The battery charge might be low, so charge the battery. There could be a fault in the brush circuit or motor; check the wires, connections, and motor. The brush motor brushes might be worn, so replace the brushes and check the commutator. Finally, there might be faulty limit switches or connections, so check them.
J
josephbrewerAug 26, 2025
How to fix little or no solution flow on my Windsor chariot iScrub 20 CSXC20 Scrubber?
- E
  Eric PhillipsAug 26, 2025
  If your Windsor Scrubber isn't providing enough solution flow to the floor, start by checking if the solution tank is empty and fill it if needed. The solution strainer might be plugged, so clean it. There could be an obstruction in the solution system plumbing, so clear it. The solution solenoid valve might be obstructed or stuck. The solution metering valve might be closed, so open it. The solenoid could be faulty, so check the solenoid valve. Finally, there might be faulty limit switches or connections, so check them.
T
Thomas JuarezAug 27, 2025
What does it mean when the battery indicator light is flashing on my Windsor chariot iScrub 20 CSXC20 Scrubber?
- A
  Amy JohnsonAug 27, 2025
  If the battery indicator light is flashing on your Windsor Scrubber, it could mean that the battery needs to be charged, so charge the battery. Alternatively, the controller might be indicating a fault code; refer to the fault code table.
C
catherine49Aug 30, 2025
Why is my Windsor chariot iScrub 20 CSXC20's scrubbing performance poor?
- T
  Thomas MartinezAug 30, 2025
  If your Windsor Scrubber exhibits poor scrubbing performance, several factors could be responsible. Debris might be caught in the scrub brush, so remove it. The brush or pad could be worn, so replace them. You might be using an improper detergent, brush, or pad, so contact equipment or application specialists. Lastly, the battery charge might be low, so charge the batteries.
M
Michael WadeSep 1, 2025
What causes the vacuum motor to not run, or run slowly on a Windsor chariot iScrub 20 CSXC20?
- E
  erinwyattSep 1, 2025
  If the vacuum motor on your Windsor Scrubber does not run, or runs slowly, it could be due to a faulty vacuum circuit or switch, so check the wires and connections. Another cause might be worn vacuum motor brushes, so replace the brushes and check the commutator. Lastly, the vacuum circuit breaker might have tripped, so reset it.
M
Melissa HernandezSep 3, 2025
What to do if my Windsor Scrubber does not change speeds?
- S
  Sarah DixonSep 3, 2025
  If your Windsor Scrubber does not change speeds, the issue might be a faulty speed control circuit or switch. In this case, check the wires and connections.
M
maxwelljesseSep 5, 2025
Why is my Windsor Scrubber only going forward or reverse?
- M
  Mr. Carl SantanaSep 5, 2025
  If your Windsor Scrubber only operates at forward speed or reverse speed, the issue might stem from a faulty forward/reverse circuit. To address this, check the wires and connections.
H
hperezSep 8, 2025
Why does my Windsor Scrubber have no machine function?
- H
  hendersonlaurenSep 8, 2025
  If your Windsor Scrubber has no machine function, it might be because the console lid is open. Close the console lid.
P
Phillip MorganSep 10, 2025
What to do if the deck won’t go down on my Windsor chariot iScrub 20 CSXC20?
- M
  Megan McdowellSep 10, 2025
  If your Windsor Scrubber deck won’t go down, the actuator circuit breaker might have tripped. Reset the actuator circuit breaker.
A
Amanda PowellSep 12, 2025
Why is there no power to my Windsor chariot iScrub 20 CSXC20?
- D
  Daniel HarrisSep 13, 2025
  If your Windsor Scrubber has no power, it could be due to several reasons: the battery might be disconnected, so check all battery cable connections; the emergency shut-off might be activated, so reset it; the battery cables might be corroded, so clean the connections; the key switch might be faulty, so replace it; the batteries might not be plugged in, so plug them in; or the on-board charger might be plugged in, so unplug it and stow the cord.

Summary

Safety Information

Important Safety Instructions

Essential safety guidelines and warnings for machine operation.

Hazard Warnings and Label Locations

Explains hazard levels and identifies safety label locations.

Operations Guide

Technical Specifications and Machine Overview

Detailed technical data, how the machine works, and its components.

Controls and Machine Operation

Details on using drive and scrub controls, and operating procedures.

Scrubbing System Operation

Information on scrub controls, modes, and squeegee operation.

Maintenance Procedures

Service Schedule and Battery Care

Recommended maintenance tasks and battery care procedures.

Scrubbing System Maintenance

Maintenance for squeegees, brushes, scrub decks, and motors.

Fluid Systems, Tanks, and Drive Components

Maintenance for fluid systems, tanks, drive units, and motors.

Transporting and General Checks

Guidelines for transporting, inclines, and general checks.

Troubleshooting Guide

General Troubleshooting

Common problems and their potential causes and solutions.

Battery Indicator Issues

Solutions for problems indicated by battery discharge indicator flashes.

Parts Identification

Machine Exterior and Operator Interface Parts

Parts for the machine's bumper, console, controls, and steering.

Drive, Chassis, and Charging System Parts

Components for the drive system, chassis, wheels, and battery charger.

Scrubbing System Components

Parts for scrub brush drivers, decks, lift, linkage, and brushes.

Fluid, Vacuum, and Squeegee Systems

Parts for the solution, recovery tank, vacuum, and squeegee systems.

Electrical, Wiring, and Spare Parts

Diagrams, wiring components, spare parts, and serial number information.

Windsor chariot iScrub 20 CSXC20 Specifications

General

Model	iScrub 20 CSXC20
Machine Type	Scrubber
Cleaning Width	20 inches
Cleaning Path	20 inches
Brush Deck Width	20 inches
Solution Tank Capacity	11 gal (41.6 L)
Recovery Tank Capacity	12 gal (45.4 L)
Power Source	Battery
Brush Speed	230 RPM
Brush Drive	Direct Drive
Battery Voltage	24V
Battery Type	Lead Acid
Machine Weight (with batteries)	550 lbs
Machine Width	21 in (53 cm)
Machine Height	41 in (104 cm)